This is an exterior MR16 recessed inground up light. It has an input voltage range of 12 - 25V DC/AC and requires external control gear. The faceplate is made of 316 stainless steel, and the housing is aluminium. The lamp holder is MR16, suitable for a max. 20W globe (globe not included). A plastic sleeve (must be installed) and a 950mm cable are included. The light comes with 8mm tempered glass that can bear a max load of 600kg. It has an IP67 rating and a 2 - year replacement warranty. A licenced electrician must install it, and an installation instructions sheet is in each box. Use circular cable in the junction to maintain the IP rating. For parallel and single connections, an appropriate IP68 connector is recommended. Ensure the IP rating suits your intended use to avoid issues.
Using this MR16 inground up light is easy. First, make sure you have a licenced electrician install it according to the instructions in the box. Connect the cable and fit the light into the plastic sleeve with slides and screws. When using, note that the input voltage should be between 12 - 25V DC/AC, and you'll need external control gear. Don't forget that the globe is not included, so you'll have to get one suitable for the MR16 lamp holder (max 20W). To keep the IP rating, use circular cable in the junction. For parallel and single connections, use an appropriate IP68 connector. For maintenance, regularly check the tempered glass (it can hold up to 600kg) for any cracks. Also, ensure the plastic sleeve is properly installed. With a 2 - year replacement warranty, you can use it with confidence as long as you follow the IP rating requirements for your intended use.
